1．规格  Specification
1.1 压缩机  Compressor

压缩机型号 Compressor Model	403DHM-64D1
压缩机型式 Compressor Type	全封闭型电动压缩机 Hermetic Motor Compressor
压缩机方式 Compression Type	涡旋式 Scroll Type
使用冷媒 Refrigerant	R22
排气容积 Displacement	64cm3/rev
润滑油 / 油量 Oil / Oil Charge	SUNISO 4GDI-HT / 1800ml
涂装 Painting	黑色 Black Color Paint
总质量(含油) Net Mass(Including Oil)	35kg
吸气管接口内径 Suction Accept I.D	Ф22.2mm
排气管接口内径 Discharge Accept I.D	Ф12.9mm
CCC认证号 CCC Certification No.	2003010704098885

 
1.2 电机  Motor

电动机型式 / 起动方式 Motor Type / Start Mode	三相感应电机 / 直接 3 Phase Induction Motor / Direct Start
极数 Pole	2极  2 Pole
额定电压 / 频率 Rated Voltage / Frequency	3Ph–346～380V-50Hz / 3Ph–380～400V-60Hz
额定转数 Rated Revolution	2,921 [50Hz] / 3,470 [60Hz]
绝缘等级 Insulation Class	F级  F Class
绕组阻抗 Winding Resistance (at 20℃)	3.03±7%Ω

 
1.3 性能  Performance

制冷能力 Capacity	11,800W [380V,50Hz] / 14,200W [400V,60Hz]
输入功率 Motor Input	3,600W [380V,50Hz] / 4,350W [400V,60Hz]
能效比 EER	3.25W/W
运行电流 Running Current	6.7A [380V,50Hz] / 7.5A [400V,60Hz]
堵转电流 Locked Rotor Ampere	49A [380V,50Hz] / 45A [400V,60Hz]
噪音 Sound Level	60dB(A) Max.
振动 Vibration	15m/s2 Max.

 
※ 制冷能力测试条件 Test condition of cooling capacity：
冷凝温度 Condensing temp.：54.4 ℃           蒸发温度 Evaporating temp.：7.2 ℃
回气温度 Return gas temp.：18.3 ℃           周围温度 Ambient temp.：35.0 ℃
膨胀阀前液体温度 Liquid temp.：46.1℃
 
1.4 一般特性  Characteristics

气密试验压力 Leak Tight Pressure	3.0MPa[高压侧 H.P. Side] / 1.5MPa[低压侧L.P. Side]
耐压试验压力Hydrostatic Strength Pressure	4.5MPa[高压侧 H.P. Side] / 2.3MPa[低压侧L.P. Side]
绝缘阻抗 Insulation Resistance	10MΩ Min.
绝缘耐压 Withstand Voltage	1,800V-1min.
残余水分量 Residual Moisture	350mg Max.
含尘量 Residual Impurities	100mg Max.

NO.	名称 Parts Name	数量 Qty	代号 Drawing NO.	备注 Remarks
1	支撑螺柱 Bolt	4	TP1-101	标准部件 Standard Parts
2	防振胶垫 Rubber Grommet B	4	TP1-102
3	防振胶座 Rubber Grommet A	4	TP1-103
4	垫圈 Washer	4	TP1-104
5	M6螺母 M6 Screw Nut	4	GB41-86-M6
6	M8螺母 M8 Screw Nut	4	GB41-86-M8
7	弹性垫圈 Spring Washer	4	GB93-87-6
8	温控器挡板 Thermostat Holder	1	TP1-105	选择部件 Option Parts
9	排气温控器 Discharge Thermostat	1	TP1-106
10	热油器 Crankcase Heater	1	TP1-110

 
3. 使用条件范围  Operating Conditions

蒸发温度 Evaporating Temp.	-15～15℃
排气温度 Discharge Temp.	(冷凝温度＋15℃)～120℃以下 (Condensing Temp.＋15℃)～120℃ Max.
绕组温度 Winding Temp.	120℃以下 Max.
压缩机外壳温度 Shell Temp.	115℃以下 Max.
运转电压 Running Voltage	额定电压±10%  Rated Voltage ±10%
起动电压 Start Up Voltage	额定电压的85％以上（压缩机端子间电压）  Minimum 85％ of the rated voltage measured at compressor terminals.
频率范围 Frequency Range	额定频率±2%  Rated Frequency ±2%
吸气压力 Suction Pressure	0.1～0.7MPa (起动、除霜等短时间运转除外；Except the short period such as start,defrost)
排气压力 Discharge Pressure	1.1～2.8MPa
压力比 Pressure Ratio	2～7.5 (起动、除霜等短时间运转除外；Except the short period such as start,defrost)
起动时的压力差 Pressure Difference At Starting	排气压力－吸气压力≤0.30MPa D.P.-S.P. less than 0.30MPa
启停周期 On/Off Period	周期为10分钟以上，停止时间必须3分钟以上 10 minutes min/cycle,OFF should be over 3 minutes
最低油量 Minimum Oil Charge	400ml Min.
异常升压/降压 Abnormal Press. Rise/Drop	上升:3.0MPa以下  Rise:3.0MPa Max.
	下降:0.2MPa以上  Drop:0.2MPa Min.
配管（铜管）应力 Copper Piping Stress	启动时:50MPa以下  Start:50MPa Max.
	运转时:10MPa以下  Run:10MPa Max.
冷媒水分含量 Refrigerant Moisture Level	60ppm以下 Max.
系统固体杂质含量 Solid Impurities Level	100mg以下 Max.
运转倾斜角度 Tilt In Operation	压缩机倾斜最大5°以内  5 deg. Max.

※ 其他注意事项  Remarks:
1.设置排气单向阀可以起到能量调节与压缩机不带压差启动；
The exhaust check valve may adjust capacity ,and startup at no pressure difference.
2.每台压缩机都需要独立设置电流、压力、温度等保护装置；
Some protected device should be mounted for any compressor ,for instance current, pressure and temperature.
3.在系统匹配时需要考虑在各种运行模式如：高落差长配管、最大注氟量等情况下的回油状况，当压缩机出厂注油量（1800ml）不能够保证压缩机运行的最低油量400ml时可以从压缩机排气侧补充适量牌号为SUNISO 4GDI-HT的冷冻机油。
It should be given our attention to oil that compressor runs for example long tube and the max. refrigerant. If compressor oil fall short of 400ml,it must be injected from the exhaust.
4.压缩机在去除吸、排气接头盖后，请勿放置10分钟以上；
Installation shall be completed within 10 minutes after removing the caps of suction and discharge tube.
5.请勿压缩空气；
Do not compress air.
6.在真空状态下请勿通电；
Do not energize under vacuumed condition.
7.在环境温度低于20℃时，必须安装油加热器（40～80W,220V）；
Crankcase heater is require if ambient temp. is below 20℃.
8.请勿反向旋转；
Do not reverse rotate.
9.运转时，各相间的电压偏差应在额定电压的3％以内；
Voltage (run):Voltage deviation each phase shall be within 3% of the rated voltage.
10.成箱压缩机包装件的叠放堆码极限为2箱,装卸过程中严禁翻滚；
Pile limits 2 pallet.Tumbling is forbidden during handling.
11.向压缩机充油或冷媒时，必须从排气侧进行；
Charge oil or refrigerant from the discharge pipe.
12.压缩机的接地装置应永久与制冷器具的接地装置连接；
The compressor’s ground should be connected with that of refrigeration system permanently and firmly.
13.并联系统中回油毛细管前必须安装过滤器。
A filter is require before capillary tube in Multiple refrigerant
福粤制冷想了解更多日立压缩机知识请点如下网站：日立压缩机，日立空调压缩机，日立变频压缩机，日立螺杆压缩机  http://www.hitachizg.com/